TURN OFF POWER TO THE FIXTURES.

REMOVE LAMPS AND BALLAST COVER.

DISCONNECT BALLAST FROM POWER SUPPLY.

REMOVE AND DISCARD EXISTING SOCKET PLATE AND BALLAST IN ACCORDANCE WITH LOCAL CODES AND REQUIREMENTS.

INSERT NEW LAMP HOLDERS INTO PROVIDED SOCKET PLATE.

INSTALL AND  CONNECT NEW BALLAST (BY OTHERS) TO LAMPHOLDERS PER DIAGRAM ON BALLAST LABEL.

SECURE SOCKET PLATES WITH "TEC" SCREWS SO THAT THE LAMPHOLDERS ARE AGAINST THE ENDS OF THE FIXTURE AND CENTERED LONGITUDINALLY

CONNECT BALLAST LEADS TO POWER SUPPLY ( ENSURE BALLAST IS GROUNDED TO FIXTURE).

NOTE: IF THE  INCOMING POWER IS END FED,  BEND CENTER TAB DOWN TO ALLOW ROOM FOR WIRES TO PASS.

SNAP R304 REFLECTOR INTO TABS LOCATED ON SOCKET PLATES.

CLEAN REFLECTOR, INSTALL LAMPS AND TURN ON POWER.